Air4G Installation Guide
Page 48
Commercial in Confidence
UGD-D00229 Rev B
Figure 33 - Adjustable Mounting Kit 2, with ‘V’ Blocks
5.5.3 Install Omni Antenna
This describes the mounting of the Omni mast mount antenna (ordered separately).
Figure 34 - possible Omni antenna array
To mount the Omni antenna for the Air4G in a mast mount configuration, perform the
following steps:
1. Assemble Omni antenna array on the ground at the installation site.
2. Attach the antennas to the mast and connect the cables while on the ground.
3. Use the mounting brackets provided with the antenna(s).
4. Carefully connect the antenna and mast assembly to its mounting bracket and tighten the
clamp bolts.
Note:
This assembly requires more than one (1) person to assemble in place.
The recommended distance between Omni antennas is determined by the frequency band, as
shown in the table below:
Table 23 - recommended distance
Frequency Distance between antennas
5.x
0.55 meters
3.x
0.85 meters
2.x
1.20 meters
0707
4 meters
5.6 Optional Mounting Antenna on Air4G
Either Antenna shown can be mounted on the Air4G unit or mast mounted.
Note:
The sunshield kit is required for this type of assembly. Contact your
supplier to order.