Centrox Instruction Manual
59
AirSep Corporation
A.
Appendix Technical Data
A.1
SPECIFICATIONS
Data in this section refer to Centrox Oxygen Concentrators. This data may vary as
per the customer’s requirements.
Centrox
Product Flow
32 SCFH (0.84 Nm
3
/hr or 15 LPM)*
Product Pressure
50 psig (345 kPa or 3.5 barg)*
Product Concentration
Up to 95%
Product Dew Point
-100°F (-73°C)
Dimensions (W x D x H)
(Nominal)
▪
Air Compressor Module
▪
PSA Concentrator Module
21 x 13 x 27 in (52 x 32 x 68 cm)
27 x 15 x 38 in (68 x 37 x 97 cm)
Weight
▪
Compressed Air Inlet
▪
Product Gas Outlet
100 lb (45 kg)
160 lb (73 kg)
Physical Connections**
Product Gas Outlet
¼” NPT x B size oxygen demand valve
Ambient Operating Conditions
Locate the oxygen generator in a well-ventilated area that is
protected from weather elements and remains between 40°F
(4°C) and 112°F (44°C)
Control Power Requirements
(Single Phase)
120 V ~ ±10%, 60 Hz, 11.0 A or 220 V ~ ±10%, 50 Hz, 5.5 A
Pressure Switch Setting***
For 120 VAC, 60 Hz power supply
(minimum)
58 psig
400 kPa
4.0 barg
(maximum)
63 psig
434 kPa
4.3 barg
Pressure Switch Setting***
For 240 VAC, 50 Hz power supply
(minimum)
52 psig
359 kPa
3.6 barg
(maximum)
58 psig
400 kPa
4.0 barg
Certifications and Approvals
CE category IIa
*SCF (Standard cubic foot) gas measured at 1 atmosphere and 70°F / Nm3 (Normal cubic meter) gas
measured at 1 atmosphere and 0°C / LPM (Liters per minute) gas measured at 1 atmosphere and 21°C.
**Check the label on the control panel for appropriate power supply.
***Data may vary as per the customer’s requirements.
Table A.1:
Centrox Specifications
