22
Maintenance
CAUTION
:
Do not disassemble the WeatherStation Instrument. There are no
user-serviceable parts inside. Removing the three screws holding the lower
housing will damage the waterproof seal, voiding the warranty.
CAUTION
: Do not immerse in water or pressure wash. Doing so may allow water
to infiltrate the WeatherStation Instrument, voiding the warranty.
CAUTION
: The reflector plate and the waterproof film found in the wind channel of
the WeatherStation Instrument are essential to its operation. The waterproof film
protects the transducers, so be careful to keep it intact. Do not to scratch the
reflector plate or damage it in any way.
CAUTION
: Keep the wind channel and any louvers or rain sensor free of spider
webs, insects, dirt, and other debris.
Cleaning
Since the WeatherStation Instrument has no moving parts, it requires minimal
maintenance. Clean the exterior with a damp cloth and mild household detergent.
Gently thread an alcohol wipe through the wind channel and under any rain sensor to
remove spider webs and any debris (Figure 12).
200WXRS, 200WXS
—Gently clean under the louvers with a duster.
Figure 12. Maintenance
(200WXRS shown)
Copyright © 2008 - 2017 Airmar Technology Corp.
reflector plate
waterproof film
wind channel
temperature sensor
rain sensor
serial number
lower housing
screw (3)
louver (5)
