$PASHS,SPD,A,9 $PASHR,ACK
Set PortA in 115.2Kbps
$PASHS,DSY,A,C<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
$PASHS,DSY,C,A<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
AT\APASSTHRU<CR><LF> OK
Wait 30 seconds before continue
ATS0=1<CR><LF>
OK
Set the number of ring before
connection
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
Remove the transparent mode
The CDMA/GSM modem base is initialized, and ready to be used by the rover.
2.2.2
Rover side
The Allegro terminal with FastSurvey shall be connected to Z-max either with Bluetooth
wireless link or serial cable to port A.
Port A
Serial cable
or
Bluetooth
In Fast Survey utility you will find, a terminal utility that allow sending command to Z-max.
2.2.2.1
Dialing to the base
Commands to send with Allegro terminal connected to port B of Z-max
Command to send to Z-max
Response from Z-max
Comments
$PASHS,SPD,A,9 $PASHR,ACK
Set PortA in 115.2Kbps
$PASHS,DSY,A,B<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
$PASHS,DSY,B,A<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
AT\APASSTHRU<CR><LF> OK
Wait 30 seconds before continue
ATD Base Phone Number
OK
Dial to the base phone number
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
Remove the transparent mode
Commands to send with Allegro terminal connected to Z-max through Bluetooth
Command to send to Z-max
Response from Z-max
Comments
$PASHS,SPD,A,9 $PASHR,ACK
Set PortA in 115.2Kbps
$PASHS,DSY,A,C<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
$PASHS,DSY,C,A<CR><LF> $PASHR,ACK
Set Z-max in transparent mode
AT\APASSTHRU<CR><LF> OK
Wait 30 seconds before continue
ATD Base Phone Number
OK
Dial to the base phone number
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
Remove the transparent mode
After a few seconds the rover is connected to the base, and receive data from the base
2.2.2.2
Hang-up the rover
Just disconnect the Airlink modem from its power source.
17/08/2007 3/
21/