215
When Time Server is enabled at the “On Demand” mode, the “Reconnect Mode” will turn out “Always on”.
•
Manual
– Click the “
Connect
” button on “
WAN Information
” in the Overview page to connect to the
Internet.
9
Idle Time :
Time to last before disconnecting PPPoE session when it is idle. Enter preferred Idle Time in
minutes. Default is “
0
”, indicates disabled. When Idle time is disabled, the “
Reconnect
Mode
” will turn out
“
Always
on
”
9
MTU :
By default, it’s
1460
bytes. MTU stands for Maximum Transmission Unit. Consult with WISP for a
correct MTU setting.
9
MPPE Encryption :
Microsoft Point-to-Point Encryption (MPPE) encrypts data in Point-to-Point
Protocol(PPP)-based dial-up connections or Point-to-Point Tunneling Protocol (PPTP) virtual private
network (VPN) connections.
128
-
bit
key (strong) and
40
-
bit
key (standard) MPPE encryption schemes are
supported. MPPE provides data security for the PPTP connection that is between the VPN client and the
VPN server.
DNS :
Check “No Default DNS Server” or “Specify DNS Server IP” radial button as desired to set up system DNS.
Î
Primary :
The IP address of the primary DNS server.
Î
Secondary :
The IP address of the secondary DNS server.
MAC Clone :
The MAC address is a 12-digit HEX code uniquely assigned to hardware as identification. Some ISPs
require you to register a MAC address in order to access to Internet. If not, you could use default MAC or clone MAC
from a PC.
Î
Keep Default MAC Address :
Keep the default MAC address of WAN port on the system.
Î
Clone MAC Address :
If you want to clone the MAC address of the PC, then click the
Clone MAC Address
button. The system will automatically detect your PC's MAC address.
The Clone MAC Address field will display MAC address of the PC connected to system. Click “Save” button can
make clone MAC effective.
Î
Manual MAC Address :
Enter the MAC address registered with your ISP.
Click
Save
button to save your changes. Click
Reboot
button to activate your changes