Fig.1
Turn off the electric circuit at the
main fuse or circuit breaker box.
Thread the motor wires through the
downrod stand cover, canopy and
downrod.Then restore support pin
and downball back by tightening
screw.
Hanger Pin
Lock Pin
Screw
Support Pin
Ball Joint
Hang the fan on hanger bracket,
and make sure the slot of ball joint
is fitted into the guide pin of hanger
bracket.
Remove the lock pin and take off
the hanger pin.Then remove screw
and slide the ball joint down to take
off support pin.
Fig.3
Insert and tighten the two collar
screws. Slide lock pin into hanger
pin.
Fig.6
Lock Pin
Collar Screws
Slot
Guide Pin
Hanger Bracket
Fig.7
Loosen the collar screws partly.
Insert the downrod into the collar.
Slide hanger pin through holes of
collar and downrod and secure with
lock pin.
Hanger Pin
Motor Wires
Downrod
Downrod Stand
Cover
Collar
Canopy
Fig.5
Motor Wires
Downrod
Downrod Stand
Cover
Canopy
Fig.4
Attach the hanger bracket to the ceiling
with spring washers, flat washers and 2
mounting screws.
Note: For sloped ceiling installation, make
sure that the hanger bracket is installed
so that the guide pin is facing upward.
Hanger
Bracket
Fig.2
Guide Pin
Flat Washer
Spring Washer
From House Wire
Terminal Block
House Wire
(AC-L)
L
(AC-N)
N
Female Connector
Female Terminal
Male Connector
Male Terminal
Fig.8
1. Make house wire connections. Follow diagram on
the left and make sure that all exposed wires are
tightened by screw on terminal block.
Note:
a.) The terminal block shown in left graph is
pre-installed on the mounting bracket.
b.) After wiring is completed, gently push wires into
hanger bracket with terminal block facing upward (if
applicable).
2. Make fixture wire connection. Plug the male
connector into female connector and plug the male
terminal into female terminal.(Do not force
it into wrong receptacle as it will cause damage.)
N
L
Fixture Wire
3
F A N C O
161031
