G e n e r a l i n f o r m a t i o n
General information
Carrying
You can carry your pager without any aid in your pocket or handbag, or with a
wrist strap, a belt clip (vertical or horizontal carrying) or a belt carrying case.
Access codes
If the device code request is enabled in your pager, the code is requested
each time the pager is switched on. The factory setting for the four-digit
device code is 1234.
To prevent unauthorised use of your pager, change the codes. Keep the new
codes secret and in a safe place separate from your pager.
Modes of operation
Your pager has two modes of operation: network mode and direct mode. In
the network mode, the pager operates using the TETRA network. In the direct
mode, the pager operates without the network, so that the devices
communicate directly with each other. In the direct mode, only some functions
of the pager are available. For more information on the direct mode, see
Direct mode on page 49.
Transmission barring
When transmission barring is active, the pager does not send any signals to
the network, and only limited network services are available. In the network
mode, the pager can only receive messages and statuses addressed to talk
groups, providing that the pager is registered to the network. In the direct
mode, the pager can receive messages and statuses. When transmission
barring is active, the pager cannot re-register to the network, for example, if it
is switched off and then on again.
P8GR_en_print.book Page 10 Thursday, November 12, 2020 6:57 PM
