Zero Gravity Laser
™
Wall Racer
Controller/Charger
NOTE:
USE ON SMOOTH, CLEAN
SURFACES ONLY!
FOR INDOOR USE ONLY.
ADULT SUPERVISION RECOMMENDED!
TO GET THE MOST OUT OF YOUR
ZERO GRAVITY LASER™
WALL RACER PLEASE READ THESE
INSTRUCTIONS FIRST!
Check to make sure contents are
complete:
• 1 Zero Gravity Laser™ Wall Racer
• 1 Controller/Charger
• 1 Instruction Guide
BATTERY INSTALLATION
CHARGING YOUR ZERO GRAVITY LASER™
1. Switch
car to “OFF”.
2. Switch
controller/
charger to
“OFF”.
3. Take out
charger
plug and
plug into
car.
4. Slide the
switch to
the “Charge”
position on
the controller.
5. Red light flashing:
Vehicle is charging.
Green & Red light
flashing together:
Vehicle is charged.
Green & Red light flashing
alternatively: error.
Green light
flashing/Red light off:
Replace AA Batteries.
6. When
charged, turn
controller/
charger
switch to
“OFF”.
• Charging should take between 30 and 50 minutes depending on how much charge is left in the car.
• NOTE: Do not charge battery immediately after use. Let the car battery cool for at least 10 minutes.
If charging is not complete in 50 minutes, replace the charger batteries.
Your Wall Climber has a pre-installed rechargeable battery inside the vehicle body. (Rechargeable battery is not replaceable.)
CONTROLLER/CHARGER
Six 1.5-V AA
Alkaline Batteries
Battery
Compartment
Battery
Compartment
Door
OFF
CHARGE
OFF
ON
CHARGE
OFF
ON
CHARGE
OFF
ON
Red
LED
Green
LED
TM
1. Requires 6 1.5-V AA alkaline batteries.
2. Open the battery door with a screwdriver.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install new batteries as shown in the polarity diagram (+/-) inside
the battery compartment.
5. Replace battery door securely.
6. Check your local laws and regulations for correct recycling and/or
battery disposal.
INSTRUCTION
GUIDE
®
1
