SWIR Line Camera Series User’s Manual
(OM150000013H-EN)
－
6
－
1.
Safety Precautions
Thank you for choosing AVALDATA’s SWIR Area Camera
series.
Please read this manual carefully and follow all safety rules
and operating instructions before using the product.
1-1
Handling Precautions
■
Do not use this product at a place where it
can be subject to spillage of chemicals.
Spilled chemical on this product may cause
short-circuit and result in fire, failure, or
deformation.
■
Do not use or store the product in a place
where it can subject to spillage of liquids
such as water and oil, a place exposed to
steam, or a place of high humidity. it may
cause failure of the product.
■
Use or store the product in a flat place.
Keep the product for protection from the
vibration or shock. It may cause failure or
deformation.
■
Be sure to supply right power and voltage
and to operate the product in condition
which meets operation/store temperature.
■
Do not use or store the product in a place
exposed to direct sunlight or a place close
to fire or heaters such as stoves. Otherwise,
it may cause failure or deformation.
■
Do not use or store the product in a dusty
place, and it may cause failure.
■
Do not use the product at a place where it
has TV, radio or cordless phone. Otherwise,
it may cause an impact on the product due
to the noise from such devices.
■
Do not use or store the product at a place
close to the equipment generating
magnetism or electric wave. Otherwise, it
may cause failure of the module.
■
Putting heavy stuff on the product may
cause failure.
■
Exposure to water or other liquids may
cause damage to the product.
■
Electrostatic discharge(ESD) causes
product damage. Be sure to use ESD safe
tools and ESD protection stuffs.
■
Be careful to avoid injury by sharp edges
while using the product.
1-2
Operating Cautions
■
When you install the product
A) Be sure that switch setting is done
correctly based on product specification.
B) Check the product works correctly
supplying power to the product after
installatation complete.
■
When you remove the product
A) Be sure to off the power before removing
the product from the system. If you
remove the product while power is
supplied, it can cause product failure.
B) Be careful when you handle with the
product right after power off. It is
recommended to handle the product
after the product is cooled down enough.
Warning
To avoid electric shock, be sure to disconnect
power cable from the product when you install or
remove the product.
