AiP ABL-005IR, Manual

Page: 44 / 72

SWIR Line Camera Series User’s Manual
(OM150000013H-EN)
－ 44 －
4-14-3
User Output
In case User Output* is selected as Line Source, it needs
to be set the signal to Assert or Negate by command User
Output.
User Output is the trigger signal controllable by software.
＜ UserOutputSelector ＞
command param1 Description
CL user-selector
0 User Output0
1 User Output1
GV UserOutputSelector
User Output0
User Output1
User Output2
※ 1
User Output3
※ 1
User Output4
※ 1
User Output5
※ 1
User Output6
※ 1
NOTE
※
1 ABL-010IR-GE is supported only.
＜ User Output Value ＞
command param1 Description
CL user-value
0 Negate
1 Assert
GV UserOutputValue
Off Negate
On Assert
If you execute the command User Output Value All , User
Output Value All Mask , all of User Output values can be
changed at once.
Setting value of User Output Value All and User Output
Value All Mask should be programmed the same, and
then it works according to User Output Value .
Settings of User Output Value All, User Output Value All
Mask is expressed by numerical value and the values
indicated below and User Output* are assigned.
＜ UserOutputValueAll ＞
command param1 Description
CL
user-value-all
user-mask-all 0 ～ 4 Bit0 ： UserOutput0
Bit1 ： UserOutput1
Bit2 ： UserOutput2 ※ 1
Bit3 ： UserOutput3 ※ 1
Bit4 ： UserOutput4 ※ 1
Bit5 ： UserOutput5 ※ 1
Bit6 ： UserOutput6 ※ 1
Default:0
GV
UserOutputValueAll
UserOutputValueAllMask
NOTE
※
1 ABL-010IR-GE is supported only.
4-14-4
Digital Noise Filter (DNF)
Digital Noise Filter(Here after DNF) able to reduce noise
in unit of 1μs is equipped in GPIO signal(GPIO in DC12V
Power Connector). Noise reduction period can be
specified independently to High/Low.
NOTE ABL-010IR-CL is not supported.
※ High/Low detection is applied to the signal only passed
Schmitt-trigger inverter.
In above figure, even though Input signal keeps being
generated in A part, the signal does not last the period of
active high level(High time=80ns), so that Line* keeps its
state as low.
After then, right after input signal lasts for the period of
active high (High time=80ns) Line* changes its state to
High.
In B part that input signal does not last for the period of
active low level, so Line* keeps high level. After then at C
part when the input signal lasts for the period of active low-
level Line* changes its stated from high to low.
Be aware that as described above, when using the digital
noise filter signal delay may occur.
GPIO[*]
Line*
A B C
High time+80ns Low
time+80ns
Digital
Noise
Filter
GPIO[*] Line*