29
AcraDyne Gen IV iAC Controller Manual
4.5.7 Bar Code Setup
Required Identifiers for Tool Enable:
Selects which
four Identifiers (ID#1-4) are required to enable tool.
Reset Identifiers on Job Complete:
Selects which four
Identifiers (ID#1-4) to reset on a job complete. Select
Identifiers by clicking on them.
Block New Identifiers While Job is Running:
Check to enable feature that ignores any barcode
scanning while a JOB is in progress
Step 1:
Click
anywhere in
body to enter
the Barcode ID
configuration
Screen or add
additional
Identifiers.
Step 2:
Enter appropriate information on Barcode ID
Configuration Screen.
Identifier Mask:
The
Mask is a string used
to compare the
received barcode
against. The
received barcode
must be at least as
long in length as the
Mask. The Mask can
also contain “don’t
care” characters of
a decimal point or
period in the string.
These characters
are counted in the
length, however,
the actual received
character in that
position doesn’t
matter.
4.5.4 Protocols
For
information
about these
settings, see
individual
protocol
instructions
on AIMCO's
website at
www.aimco-
global.com
4.5.5 Front Panel Buttons
Enable/ Disable front panel buttons on controller
console.
4.5.6 Power Up
Allows user several
“Job” choices
upon controller
Power Up:
Power Up Job
Number:
Controller
will power up on the job # selected.
•
Last Job:
When “Last job” is selected, controller
will power up on last job selected prior to being
Powered Down.
Power Up Job Action
•
Reset Job:
Job will be reset when controller is
Powered Up.
•
Wait for job Reset:
Controller will wait for an External
Job reset command upon Power Up and will retain
job information existing prior to power down.
