11
6.3 – Configuration issues
Should any connection issue arise, make sure that LCU-One CAN is correctly connected to the master unit. After having inspected its power
supply cables and when the CAN connection cable is correctly plugged in the EXP port, check the connectivity using Race Studio 3
following these steps:
•
Connect your AiM master unit and run Race Studio 3 software.
•
Press
Devices
and select yours in Connected Devices label.
•
On the main panel on the right, select the Firmware tab and check if the LCU-One CAN is listed (see image).
•
If available, make sure the configuration is correctly set and transmitted to the main AiM device.
An alternative way to check if the LCU-One CAN is correctly recognized is to use the AIM display: access the Menu – System Info – Net Info