1
Electrocution Hazards
1.
DANGER
• This machine is not electrically
insulated. Do not use the machine near
electric power lines.
• Keep a safe distance from electric power
lines and apparatus. For safe distance,
check your national or local regulations.
If no national or local regulation is
available, use the table below.
M085E100
fi g. 1‒1
Voltage
(Phase to Phase)
Minimum Safe
Approach Distance
0 to 300 V
Avoid Contact
over 300 V to 50 kV
3.05 m
over 50 kV to 200 kV
4.60 m
over 200 kV to 350 kV
6.10 m
over 350 kV to 500 kV
7.62 m
over 500 kV to 750 kV
10.67 m
over 750 kV to 1000 kV
13.72 m
table 1-1
• Keep away from the machine if it
contacts energized power lines. Until
energized power lines are shut down,
any persons in the platform must not
operate the machine and any persons
on the ground must not touch the
machine.
• Do not use the machine during
lightning or storms. Stop operation in
bad weather.
• Do not use the machine as a ground for
welding.
Tip Over Hazards
2.
DANGER
• Do not exceed the platform capacity as
indicated on the serial number plate.
M085E200
fi g. 1‒2
• Do not hang or attach loads to the
machine. Spread loads evenly on the
platform.
• Do not use the machine as a crane or
lift.
M085E300
fi g. 1‒3
Safety Rules
