I-27
Z-038791_EN • Rev A
P
roduct
I
nstallatIon
Installing and Removing the Condensate Trap
Conditions:
Tools and Material:
The following, provided with the boiler:
î
Condensate trap
î
Clip
î
Adjustable hose (175 mm to 390 mm)
First Installation:
1.
Install the O-ring (
1
) on the boiler connection
(
9
), at the bottom of the boiler.
2.
Slide the fitting (
8
) end of the condensate
trap body (
6
) on the boiler connection (
9
).
3.
Insert clip (
2
) into the fitting (
8
) to lock the
condensate trap in position.
4.
Connect the adjustable hose to the conden-
sate trap connection (
4
).
5.
Adjust the hose length by pulling on the hose
as much as required (max. length : 390 mm).
6.
Connect the condensate trap hose to a con-
densate neutralisation system if required, or
directly to the drain.
Removal Procedure for maintenance:
1.
Disconnect the hose from the condensate
trap connection (
4
).
OFF
When installing the hose
make sure that it goes down-
wards, to prevent conden-
sates from being stuck in the
hose.
i
1
6
2
8
7
4
5
2.
Holding the condensate trap body (
6
) with
one hand, rotate the locking ring (
7
) coun-
terclockwise to unlock. Retain ring for rein-
stallation.
3.
Pull the condensate trap body (
6
) away from
the fitting (
8
).
At removal, make sure not to lose
the condensate trap seal (
3
) and
ball (
5
), and to retain them for lat-
er reinstallation.
Installation Procedure after maintenance:
1.
Verify that the ball (
5
) is inside the condensate
trap body (
6
) and install the upper seal (
3
).
For correct operation of the con-
densate trap, make sure that the in-
ner ball and upper seal are installed.
2.
Slide the condensate trap body on the fitting (
8
).
3.
Screw the locking ring (
7
) to lock in position
4.
Connect the adjustable hose to the conden-
sate trap connection (
4
).
Follow-on task(s):
1.
Before operating the boiler, fill the syphon with
water by pouring water into the flue duct.
Fig. 8. Condensate Trap Installation
9
3
