• Rear Panel Controls & Description
5
SWX-200P
11
10
9
8
2
3
4
5
6
7
12
1
1.
POWER Switch
8.
VOLUME Control
For adjusting the output level of the subwoofer.
2.
POWER LED
This LED glows when the power is switched ON.
9.
Crossover Frequency Selector Switch
This switch selects the high frequency at which
3.
CLIP LED
the signal to the subwoofer is cut off. 80Hz or
This LED glows when the output is at clipping
120Hz can be selected.
level.
10. Preamplifier Input Jack Socket
4.
RESET Button
For accepting an unbalanced signal from a
This button pops out when the circuit protector
cassette player/ recorder or the preamp out of an
trips. The circuit protector prevents the powered
audio amplifier. Sensitivity is 200mV.
subwoofer from getting damaged on account of
short circuits, DC offset and Overdrive conditions.
11. Line Input Jack socket
Rectify the cause and press the RESET button
For accepting an unbalanced signal from an
for resetting normal operation of the subwoofer.
audio mixing console or the line out of an audio
amplifier. Sensitivity is 1V.
5.
FAULT LED
This LED glows in either case when the output is
12. AC Inlet socket with built in fuse (Rating 10
shorted, in case of DC offset or overdrive
AMP 250V)
conditions.
Connect the provided AC Mains cable in this socket
for AC mains operation. The fuse protects the
6.
RESET Button
amplifier from any excessive current flow. An
7.
FAULT LED
additional 3A fuse is also provided as an accessory.
20H
z
1