ahlmann AS 150, Operating Instructions Manual, Page: 17 / 113

S150/S151/S152/Z152 1-11
Safety regulations 1
1.6.4 Oil, grease and other chemical
substances
1.6.4.1 The relevant safety regulations must be observed
when using oil, grease or other chemical substances.
1.6.4.2 Caution when working with hot fuel and other
accessory material (danger of burning and scalding).
1.6.4.3 Caution when working with brake fluid and battery
acid.
TOXIC AND CAUSTIC!
1.6.4.4 Be careful when working with fuel.
FIRE HAZARD!
- Before refuel, switch off engine and remove ignition key.
- Do not refuel in a closed operating area.
- Never refuel near open fire or sparks.
- Do not smoke during refueling.
- Immediately wipe up spilled fuel.
- Keep machine free of fuel, oil and grease.
1.6.5 Gas, dust, steam, smoke
1.6.5.1 The machine may only be started and run in
closed operating areas where there is sufficient ventilation.
The regulations for the respective working site must be
strictly observed.
1.6.5.2 Only carry out welding, burning and grinding work
on the machine when this is explicitly approved. Otherwise
danger of fire and explosion!
1.6.5.3 Before carrying out welding, burning and grinding
work clean the machine and its vicinity from combustibles
and make sure that the room is adequately ventilated.
Explosion hazard!
1.7 Transport and towing, restart
1.7.1 The machine may only be towed if the brakes and
steering function.
1.7.2 Towing may be carried out only by means of an
adequately dimensioned towing bar in connection with
towing devices.
1.7.3 When towing drive slowly. Persons must not
remain near the towing bar.