4 Connection test
English - 21 –
The settings in the tabs not mentioned here may only be changed
upon instructions of our technical support.
If you change these settings, the WiFi module may no longer function
as requested and may have to be returned in order to be reset.
15.
If you have set the WiFi module as Client in the tab
Network
in the segment
DHCP
, ask your network administrator for the IP address of the WiFi
module.
Connection test
1.
Tick the checkbox next to
Reset Module Going To Data Mode
.
2.
Click on the button
Data Mode.
➢
The orange LED of the WiFi module starts flashing.
➢
As soon as the WiFi connection between the WiFi module and the WiFi
access point has been established, the orange LED will light permanently.
Do
not
close the software
Serial Port Adapter Toolbox
during the
connection test.
3.
Connect the PC with the same WiFi access point as the WiFI module.
4.
In addition to the software Serial Port Adapter Toolbox, open the software
ALMEMO
®
Control.
5.
In the welcome screen click on
Interface.
6.
Open the tab
IP network.
7.
Enter the IP address of the WiFi module in the field
IP address or host
.
8.
In the field
Port
, enter the port that you have set in step 13 in chapter 3.2
(usually 10001).
