AHI Carrier Ceiling Type, Installation Manual

Page: 6 / 25

5
installation manual
3. Wall Mounting Installtion
2. Ceiling Installation
Fig.5-8
Locate the hanging arm on the hanging screw bolt.
(Refer to Fig. 5-9)
Screw nut
Washer
Hanging
screw bolt
Hanging arm
Fig.5-9
20
～
25mm
Fig.5-7
STEEL ROOF BEAM STRUCTRUE
Hanging screw bolt
Hanging
bolts
Supporting
angle steel
Install and use directly the supporting angle steel.
2 Install the indoor unit.
Fig.5-4
Fig.5-5
Fig.5-6
Fig.5-7
NEW CONCRETE BRICKS
FOR ORIGINAL CONCRETE BRICKS
Steel bar
Embedding screw bolt
(Pipe hanging and embedding screw bolt)
(Blade shape
insertion)
(Slide insertion)
Inlaying or embedding the screw bolts.
Install the hanging hook with expansible bolt into the concrete
deep to 45~50mm to prevent loose.
Remove the side board and the grille.
(Refer to Fig. 5-8)
Side board
Grille
Hanging arm
Hanging
screw bolt
20mm
The dimension of the unit
5.3
Table 5-1
6.1 Installation Place
6. OUTDOOR UNIT INSTALLATION
The outdoor unit should be installed in the location that
meets the following requiements:
unit ： mm
Fig. 5-10
Fig. 5-11
Fig. 5-12
D. Connecting point of
refrigerant pipe
(D.gas side)
Drain point
Downward declicity lower between(1-2)/100
E. Connecting point of
refrigerant pipe
(E. Liquid side)
There is enough room for installation and maintenance.
The air outlet and the air inlet are not impeded, and can
not be reached by strong wind.
It must be a dry and well ventilating place.
The support is flat and horizontal and can stand the
weight of the outdoor unit. And will no additional noise or
vibration.
Your neighborhood will not feel uncomfortable with the
noise or expelled air.
It is easy to install the connecting pipes or cables.
Determine the air outlet direction where the discharged
air is not blocked.
There is no danger of fire due to leakage of inflammable
gas.
MODEL
30~48
18~24
A B D E C
1068 675 235 983
60
220 675 235 1565 1650
220
1285 675 235 1200 220
36~48
220 675 235 1565 1650