OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
94
Fig. 99
Fig. 100
4.11
DESCRIPTION OF THE ELECTRICAL SYSTEM OF THE TRACTOR
The main components of the tractor’s electrical system are described below.
4.11.1
BATTERY
The battery with a rated voltage of 12 V is a source of electric power for the entire power supply
system of the tractor. The battery characteristics are described in the chapter “Technical data”.
Make sure that the battery is always clean and all
terminals are tightened and greased. It is
recommended to apply a lubricating grease to all the
terminals before they are tightened to significantly
reduce the risk of corrosion.
Start the engine as instructed, see chapter “Starting
the tractor”.
Access
The battery is installed directly under the engine
cover, in front of the radiators. Occasionally check
the electrolyte level (it must be between the MIN
and MAX marks) and add some distilled water, if
necessary and allowed by the battery model. If the
tractor will not be used for an extended period of
time in the winter and with low outdoor
temperatures, make sure to remove the battery from
the tractor and store it somewhere warm.
4.11.2
ELECTRIC STARTER
An electric starter is an electric motor connected to the engine flywheel through a gear wheel. It
is directly powered by the battery. Characteristics of the electric starter are described in the
chapter “Technical data”.
Summary of Contents for AGT 106
