OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
71
Fig. 70
4.8.4
OPERATING CONTROLS (PTO DRIVE SHAFT)
The figure below illustrates all controls related to the operation of the PTO drive shaft. The data
regarding the rotation speed of the drive shaft are provided in the chapter “Technical data – PTO
drive shaft”.
1.
The rear PTO drive shaft switch
The switch is located on the console and is used to engage and disengage the rear PTO drive
shaft. The shaft can only be engaged if all the other operating controls (levers) are functional.
2.
The power take-off shaft lever
allows for the selection of the drive mode for the PTO
drive shaft.
Use the lever to choose between two positions:
•
“Position N” – The lever is in neutral position, the PTO drive shaft is disengaged.
•
“Position 1” – The standard method of PTO drive shaft connection, directly to the engine;
move the lever downwards. The PTO drive shaft rotates independently, at the number of
engine revolutions (constant rotation to the right).
Summary of Contents for AGT 106
