OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
112
Fig. 126
6.2
ADJUSTING THE LIGHTS
This chapter describers the lights on the tractor, which can be adjusted.
6.2.1
ADJUSTING THE FRONT HEADLIGHTS
To adjust the front headlights, position the tractor on a horizontal surface, make sure the tyre
pressure is correctly adjusted and that the front wheels are straight. Position the tractor at a
distance of 5 m from the wall with the low beam headlights on and check if the headlights are
correctly positioned. If the headlights are not positioned properly, adjust them; see Fig. 127.
1 - projection points at the middle height of the headlight beam on the wall
2 - distance between the tractor headlights and the wall
3 - distance between the headlights
B - height of the headlight beam
x - distance between the middle of the headlight beam and the horizontal axis
IMPORTANT:
Please note that the illustration is adapted for countries with
right-hand traffic. In countries with a left-hand traffic system, the projection area
of headlights on the wall must be symmetrical.
The ends of the light field on the wall must always point to the edge of the road.
Summary of Contents for AGT 106
