INSTRUCTIONS FOR USE
AGP 1000 – 2000 PRO
Rev.02/2019
30
7
DETAILED DESCRIPTION WITH OPERATING INSTRUCTIONS
The mist blower's frame is made of a welded steel structure, comprising the main reservoir with a
rinsing reservoir and a clean water (hand washing) reservoir. The bottom section contains an
integrated pump, suction filters and flow control valves. The rear section of the mist blower
contains a blower and a multiplier gearbox. The multiplier gearbox and the pump are connected to
the shaft and the flange.
The front section of the mist blowers also contains a pressure regulator with diverter valves and a
control panel that can be transferred in the tractor cab. For more details on the regulators and their
components, see chapter 10.
7.1
Reservoir
The reservoirs are all made from chemically resistant polyethylene, featuring rounded edges and
smooth interior and exterior surfaces to enable efficient cleaning. The reservoir has a sloping
bottom to ensure complete emptying. There is a lid with a strainer mounted at the top of the main
reservoir. Do not remove the strainer when the main reservoir is filled with a spraying agent or
water.
The front side of the main reservoir contains an engraved litre scale with a transparent hose
attached next to it, containing a floating red ball for easier reading of the quantity of chemical
agent in the reservoir.
7.2
Lid of the reservoir
The reservoir's lid consists of two parts. The smaller middle lid is used for easier filling of the
reservoir with water. It is recommended to use clean water for filling the reservoir (without any
dirt particles). Turn the lid to the left to open it or to the right to close it.
Slika 7.1
WARNING: Occasionally, it is necessary to check the oil level in the
multiplier gearbox and lubricate the cross joints on the universal joint (after
approx. 50 hours of operation)!
WARNING: Do not remove the strainer when the reservoir is filled with
water or spraying agents! Use personal protective equipment when handling
plant protection products!
