Agriframes, Journal house, Hartcliffe Way, Bristol, BS3 5RJ
Order line: 0845 260 44 50 Fax: 0117 934 17 91
Order on-line: www.agriframes.co.uk
Assembly Instructions for 12ft Landscape Monet Wall Arch
Product code: 50172
Please read these instructions carefully. They are designed to make assembly quick and easy. Please
check you have received all the components and refer to the diagrams.
Number
Component
2
¼ hoop (plain ends)
2
¼ hoop (reduced one end)
2
84” upright
6
22” spacer bar (1” width)
1
22½” spacer bar (
7
/
8
” width)
2
6” fixing tube (reduced one end)
1
Holemaker
3
5x4 Lattice
Assembly requires a rubber mallet, Phillips screwdriver, spirit level and tape measure.
Installation will require a club hammer or similar and a drill.
1)
Tap an end plug into the bottom of each upright. Place two ½” screws in
each T joint, but only tighten the screws enough to hold them in. Make
sure the screw points do not protrude into the inside of the joints as they
will scratch the coating when they are attached to the tubes. (The third
hole of each joint is used during final assembly).
2)
Tap a T joint onto both ends of the 22½” spacer. Place the bar on a flat
surface and make sure the joints are parallel. When the joints are fully
connected there should be 18½” of tube left exposed (as illustrated).
3)
Take the four quarter hoops, four of the 21¾” spacers, eight Opto joints and the spacer
assembly from above. Refer to the diagrams on the next page and assemble the roof section of
the arch. Measure the diagonals to ensure the structure is square. Note that the spacer with the
T joints goes on the side of the arch that will be attached to the wall, as shown in the diagram.
4)
Place the assembled roof section in the site you intend to position the arch, so that it is up
against the wall and mark out the positions of the two uprights. Use the Holemaker provided
to make 15” deep holes at the marks. Ensure the holes are the same depth and vertical.
5)
Take the two 84” uprights, the remaining two 21¾” spacer bars and four Opto joints. Place
one upright in each hole, end plug down. Check that the tops of the uprights are level. Attach
the spacers to the uprights using the joints as shown.
6)
Slide a moisture seal onto the top of each upright and connect the roof section onto the
uprights. Slide the moisture seals up to cover the tube joins.
7)
Connect the 6” tubes into the roof and mark the position of the fixing screws on the wall.
Remove the two 6” tubes and drill the holes. Place a rawl plug in each hole.
8)
Slide a moisture seal onto the reduced ends of the 6” tubes and connect them to the roof again.
Slide the moisture seals up to cover the joins and then attach the arch to the wall using the
screws and washers provided.
18½”
