5
Maintenance and Repair
64
Hydrostatic implement carrier agria 5900 Cyclone
Clutch play
1
Hand lever
2
Shaped spring
3
Cable pull thread end
4
Adjusting pin
Check play/adjustment before each startup. Re-
adjust if necessary (in particular during the run-
ning-in period after initial startup and after the
clutch lining has been replaced).
Clutch:
X = 1 ... 2 mm (clutch play)
= Bowden cable in hand lever bearing in-
serted in
down
position.
Adjustment
Remove shaped spring (2) and remove the ca-
ble pull end (3) with the adjusting pin (4) from the
retainer in the hand lever.
Screw the adjusting pin in / out until there is a
distance "X" or idling at position 0.
Reinsert the cable pull end with the adjusting
pin in the retainer and install the shaped spring
(2).
Summary of Contents for Cyclone 5900
