AGRETO AgriCounter Load
© AGRETO electronics GmbH
page:17
9
Maintenance and cleaning
The AgriCounter basically does not require ongoing maintenance.
If the display is dirty, clean it for reading.
If the battery symbol is lit, replace the batteries.
10
Troubleshooting
10.1
The battery symbol lights up
The batteries need to be replaced, follow these steps:
Remove the seal and the seal wire.
Remove the housing and remove the meter.
Remove the old batteries and dispose them properly.
Insert 2 new AAA batteries into the device in the specified direction.
Mount the counter again on the mounting plate.
Seal the device again with a new seal wire and a new seal.
10.2
Loads are not counted completely
It is likely that the sequenz for counting a load will not be completed.
Check the set angle
A1
for the center position.
Make sure that the set times
t1
and
t2
are safely reached, reduce times
when needed.
10.3
Too many loads are counted
It is likely that parts of the sequenz for counting a load will be skipped.
Check the set angle
A1
for the center position.
Make sure that the set times
t1
and
t2
are sufficiently high that
fluctations of the device by the middle angle do not lead to counting
additional loads. Increase times when needed.
