10
2 Sec
.
Manual Mode
To use the instrument also for larger grades , e.g. roofs, it is possible to
switch off the automatic levelling. To activate this manual mode press
and hold the on button for at least 2 seconds. The display shows the
hand symbol. Now the laser can be inclined manually and the fine
alignment can be done with the arrow keys. Therefore press the X/Y
button to move the x direction, press the button again to move the y
direction. In the manual mode there is no tilt control for the position.
Operation with the remote control
With the optional available remote control all
functions of the laser can be controlled. Just the
manual mode can not be activated to avoid an
unintentional use. Turn on the remote control by
pressing any key. The display shows the same
symbols as the laser instrument.
If the laser has stopped in grade mode (Tilt control)
the X/Y and rotation button can be pressed
simultaneously for 2 seconds to confirm and restart
the laser.
If a V and three bars are shown, there is no
communication with the laser possible.
This can have the following reasons:
-
The laser instrument is turned off
-
The communication channel is different (see special functions)
-
The distance to the laser is too large
The remote control turns off after one minute without use. This time can be
changed (see special functions). To switch off the laser and the remote control,
hold both arrow keys pressed for 2 seconds.
Do not transmit while in pocket or when held close to the body.
Change of batteries of the remote control
The battery symbol on the remote refers to the batteries in the remote, not the
laser. If the battery symbol is flashing, the batteries are empty. Take off the battery
cover and replace the batteries with new ones. Always use two new batteries size
AAA (LR03) from same type. Do not mix old and new batteries as their power will
decrease.
