Agilent Technologies TwisTorr 305-IC SF, User Manual

Page: 257 / 279

Technical Information
Agilent TwisTorr 305-ICQ & 305-IC SF User Manual 257
Window Description
Table 7 Window meanings
Win # Read Write Type Name Meaning Default
(Factory
Set)
0 Always Serial L Start/Stop Start/Stop command
Stop
1 Always Serial L Low Speed Low Speed command
Off
8 Always Always A Serial/Remote Configures controller
Remote
100 Always
Stop &
Serial
L Soft Start Enable/Disable Soft Start option
Off
101
Always
Always
N
Setpoint Type
It defines set point type:
0 = Freqency
1 = Power
2 = Time
3 = Normal Frequency
102 Always Always N Setpoint Value It defines the threshold value for Set Point
720
103 Always Always N Setpoint Delay It defines the setpoint mask time from start
0
104
Always
Always
L
Setpoint Logic
It defines the functionally logic. “High level active” indicates an
output ON when the signal is above the threshold and “Low level
active” is the opposite. Direct
105 Always Always N Setpoint histeresis It defines the percentage value of Set Point Hysteresis
2
108
Always
Always
N
Baud Rate
It defines the serial communication baud rate:
0 = 600 bit/s
1 = 1200 bit/s
2 = 2400 bit/s
3 = 4800 bit/s
4 = 9600 bit/s
5 = 19200 bit/s
6 = 38400 bit/s 9600 bit/s
109 Always Always L Pump Life Reset Pump Life Reset
---
110 Always Always L Interlock Type
It defines the interlock type. The interlock can be checked at start
or continuously
Continuous
111
Always
Always
N
Analog Output
Type
It defines the analog output type:
0 = Frequency
1 = Power
2 = Body Temperature Frequency
117 Always Always N
Low Speed Adjust
Frequency
It defines the Low Speed frequency value
700Hz
120 Always Always N Target Frequency It defines the target excitation frequency
1010Hz
121 Always Always N
Maximum
frequency
It defines the maximum frequency settable by WIN120
1010Hz
122 Always Always L Set vent valve Set vent valve
Off