Agilent Technologies R Series, User Manual

Page: 117 / 220

83 Chapter 4: Performing a run
BenchCel Microplate Handling Workstation R-Series User Guide
Performing pre-run checks
About this topic
Before you start a protocol run, you should check the BenchCel
Workstation to ensure optimum operation. This topic provides the list
you should check before each protocol run.
Procedure
To check that the BenchCel Workstation is ready for a run:
1. Make sure there are no stray microplates in robot-accessible
locations, including:
‹
Platepads
‹
External device plate stages
‹
Third-party device areas that will accept labware from the
BenchCel Workstation
2. Remove any obstacle in the robot’s pathways. Consider the path of
the robot head and arms.
3. For the devices that require compressed air, make sure the air
pressures meet the operating requirements. For the BenchCel
Workstation air supply requirements, see “Verifying laboratory
requirements” on page 29. For other Velocity11 devices, check the
user documentation for the device. For third-party devices, check
the product’s user documentation.
To check the BenchCel Workstation internal air pressure, see
“Adjusting the stacker gripper pressure” on page 131.
4. Make sure all devices and accessories are set up correctly and
prepared for the run. For instructions, see the user documentation
for the device or accessory.
Related topics
For information about... See...
BenchCel device air source
requirements “Verifying laboratory requirements” on
page 29
External device air source
requirements External device user documentation
Diagnosing air pressure problems “Maintenance and troubleshooting” on
page 91