Installation (Getting Started)
2
Installation and Verification Manual
47
20
Change the Transmitter Settings
Signal Rate
to
OC-12
and
set the Wavelength to the be same as the Transmit Port
connected in set-up.
21
Set the
Laser to ON
and
c
heck the laser LED is illuminated
at the connected 5 2Mb/s - 2.5 Gb/s Output Port on the
OmniBER OTN’s connector panel.
22
Repeat
to
to confirm correct operation.
23
Press
<Window>
key to highlight the
Transmitter Settings
window and set the
Laser
to
OFF
.
24
Disconnect all loopback connections.
Figure 5
622 Mb/s Loopback Connection
iii
15 dB Optical Attenuator
to ensure level is within
Receiver Input Range
Optical
Patch
Cord
Note 1 - Either of the [52Mb/s - 2.5Gb/s] Transmitter Outputs may
be used if both 1310 and 1550 nm ports are fitted.
Note 2 - The 52 - 622 Mb/s Receiver port may be combined with
the 2.5Gb/s Receiver port. Separate ports were only supplied on
initial units. Connect the cables accordingly.
52 Mb/s -
2.5 Gb/s
Optical Out
Ports
52 -622 Mb/s
Optical In
Port.
See Note 2
panther3_iv.book Page 47 Wednesday, January 15, 2003 12:03 PM