Agilent Technologies N9360A, Programming Manual

Page: 87 / 180

Programming Command Reference
5
N9360A Multi UE Tester W-CDMA Programming Manual 5-41
Talk Test Result
TESTs:AUTO:MEASure:TALK PASS|FAIL
This command sets the test result of the Talk test step to pass or
fail. The parameter is
PASS
or
FAIL
.
Signaling State
TESTs:AUTO:MEASure:SIGNaling:STATe?
This query command returns the test step currently executed in
a test cycle. The return value contains the currently executed
status of 12 bits as follows.
bit 0(1): Location Update
bit 1(2): MS Call
bit 2(4): Talk
bit 3(8): MS Release
bit 4(16): BS Call(AMR)
bit 5(32): Talk
bit 6(64): BS Release
bit 7(128): BS Call(RMC)
bit 8(256):RF Test
bit 9(512): BS Release
bit 10(1024): Measurement end with test result
bit 11(2048): Measurement end without test result
(Aborted or Time out error occurred)
The executed step is set to
1
, and the others are set to
0
.
The value in the parentheses is decimal value for each bit. Refer
to
Setting and Querying the Registers on page 14 .
Command Reference for Test Result (Signaling and RF Test)
The following query commands return the test results.