Agilent Technologies N9360A, Programming Manual, Page: 107 / 180

Programming Command Reference
5
N9360A Multi UE Tester W-CDMA Programming Manual 5-61
•
<real 3>
(up to 6 letters) is the measured data ranging from
-99.99
to
0.00
in dB. If measurement result is out of range
or Origin Offset is not measured, the value
-99.99
is
returned.
BER Measurement
TESTs:MANual:RESults:BER?
This query command returns the BER measurement result values,
<int 1>
,
<int 2>
, and
<real 3>
. Each value is separated by a
comma.
•
<int 1>
(1 digit) is
0
if measurement result is within the
measurement range, or
1
if measurement result is out of
range or BER is not measured.
•
<int 2>
(1 digit) is the test result for the pass (0) or fail (1).
•
<real 3>
(up to 7 letters) is the measured data ranging from
0.00
to
-100.00
in %. If measurement result is out of range
or BER is not measured, the value
+99.99
is returned.
CPICH RSCP Measurement
TESTs:MANual:RESults:CPichRScp?
This query command returns the CPICH RSCP measurement
result values,
<int 1>
,
<int 2>
, and
<int 3>
. Each value is
separated by a comma.
•
<int 1>
(1 digit) is
0
after measurement, or
1
if CPICH RSCP
is not measured.
•
<int 2>
(1 digit) is the same value as that of
<int 1>
.
(Decision with limits is not made.)
•
<real 3>
(up to 6 letters) is the measured data, or
-99
if
CPICH RSCP is not measured.
Command Reference for MS Information
The following MS Information commands are used to get
information on the mobile phone under test.