Agilent Technologies N5340A, Installation Manual

Page: 22 / 34

22 Installation Guide
3
Installing OBSAI Protocol Tester
3
Click Next .
A message box appears that prompts you to attach the USB network
adapter to the Controller PC.
4
Attach the USB network adapter to the Controller PC.
5
Click Yes .
A message box, displaying the USB network adapter and DHCP settings,
appears.
6
Click Yes .
A message box, displaying the Settings successfully modified message,
appears.
7
Click OK .
The InstallShield Wizard Complete screen appears. This screen prompts
you to restart your computer.
8
Select Yes, I want to restart my computer now .
9
Click Finish .
Uninstalling the USB Network Adapter
Once you have used the USB network adapter in the installation process,
you can remove it. However, doing this does not releases the IP address
assigned to the USB network adapter. Therefore, any attempts to use that
port displays an error, which prompts that the IP address is already
assigned to a device. To avoid this situation, uninstall the USB network
adapter before physically removing it from the computer.
To uninstall the USB network adapter
1 Right- click the My Computer icon.
2 Select Manage from right- click menu.
The Computer Management window appears ( Figure 4 ).
N O T E
If you are using the USB network adapter, and has already used the Config
Helper tool to configure the LAN interface and DHCP, jump to
Chapter 4 ,
Getting Started on page 29.