Agilent Technologies Keysight N9310A, User Manual

Page: 40 / 188

34 N9310A User’s Guide
3 Using Functions
Additional Settings for a Step Sweep
There are also other four setting items that have effects on
the sweep:
•
Sweep Trigger
You can set the sweep trigger to any of the following
three choices:
Immediate/Trigger Key/EXT
•
Point Trigger :
You can set the point trigger to any of the following three
choices:
Immediate/Trigger Key/EXT
•
Sweep Repeat
:
Cont / Single
You can set the sweep repeat to either
Cont
or
Single
.
If set to
Cont
, the signal generator sweeps from the start
point to the stop point and cycles continuously.
If set to
Single
, the signal generator sweeps from the start
point to the stop point for only one circle.
•
Sweep Direction: Up/Down
Take RF sweep for example, as you enable RF sweep by
pressing
>
Sweep Mode > RF
, the signal generator performs as
below, according to combinatorial settings of sweep trigger
and point trigger.
Sweep
Sweep
Trigger
Point
Trigger
Sweep Performance
IMM IMM
Pressing
>Sweep mode > RF
initiates sweeping immediately and
automatically. Pressing
>Sweep mode >Off
closes the sweep.
IMM Key
Pressing
>Sweep mode > RF
enables the RF sweep, then
pressing the
Trigger key
initiates sweeping over the points
manually.
Sweep
Sweep
Sweep