Agilent Technologies InfiniiVision 7000A Series, Programmer'S Manual

Page: 495 / 922

Commands by Subsystem
5
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide 495
:TRIGger:EBURst Commands
The :TRIGger:EDGE:SOURce command is used to specify the source
channel for the Nth Edge Burst trigger. If an analog channel is selected as
the source, the :TRIGger:EDGE:LEVel command is used to set the Nth Edge
Burst trigger level. If a digital channel is selected as the source, the
:DIGital<n>:THReshold or :POD<n>:THReshold command is used to set the
Nth Edge Burst trigger level.
Table 80 :TRIGger:EBURst Commands Summary
Command Query Options and Query Returns
:TRIGger:EBURst:COUNt
<count> (see
page 496 )
:TRIGger:EBURst:COUNt
? (see page 496 )
<count> ::= integer in NR1 format
:TRIGger:EBURst:IDLE
<time_value> (see
page 497 )
:TRIGger:EBURst:IDLE?
(see page 497 )
<time_value> ::= time in seconds
in NR3 format
:TRIGger:EBURst:SLOPe
<slope> (see
page 498 )
:TRIGger:EBURst:SLOPe
? (see page 498 )
<slope> ::= {NEGative | POSitive}