Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 970 / 1232

970 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
32
:WGEN Commands
:WGEN:FUNCtion
(see page 1088 )
Command Syntax
:WGEN:FUNCtion <signal>
<signal> ::= {SINusoid | SQUare | RAMP | PULSe | DC | NOISe | SINC
| EXPRise | EXPFall | CARDiac | GAUSsian | ARBitrary}
The :WGEN:FUNCtion command selects the type of waveform:
Waveform
Type Characteristics Frequency
Range Max.
Amplitude
(High-Z)
1
Offset
(High-Z)
1
SINusoid Use these commands to set the sine signal
parameters:
•
":WGEN:FREQuency" on page 969
•
":WGEN:PERiod" on page 979
•
":WGEN:VOLTage" on page 981
•
":WGEN:VOLTage:OFFSet" on page 984
•
":WGEN:VOLTage:HIGH" on page 982
•
":WGEN:VOLTage:LOW" on page 983
100 mHz to
20 MHz 20 mVpp to
5 Vpp ±2.50 V
SQUare Use these commands to set the square wave
signal parameters:
•
":WGEN:FREQuency" on page 969
•
":WGEN:PERiod" on page 979
•
":WGEN:VOLTage" on page 981
•
":WGEN:VOLTage:OFFSet" on page 984
•
":WGEN:VOLTage:HIGH" on page 982
•
":WGEN:VOLTage:LOW" on page 983
•
":WGEN:FUNCtion:SQUare:DCYCle" on
page 975
The duty cycle can be adjusted from 20% to 80%.
100 mHz to
10 MHz 20 mVpp to
5 Vpp ±2.50 V
RAMP Use these commands to set the ramp signal
parameters:
•
":WGEN:FREQuency" on page 969
•
":WGEN:PERiod" on page 979
•
":WGEN:VOLTage" on page 981
•
":WGEN:VOLTage:OFFSet" on page 984
•
":WGEN:VOLTage:HIGH" on page 982
•
":WGEN:VOLTage:LOW" on page 983
•
":WGEN:FUNCtion:RAMP:SYMMetry" on
page 974
Symmetry represents the amount of time per cycle
that the ramp waveform is rising and can be
adjusted from 0% to 100%.
100 mHz to
200 kHz 20 mVpp to
5 Vpp ±2.50 V