Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 331 / 1232

:FUNCtion Commands
15
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 331
:FUNCtion:OPERation
(see page 1088 )
Command Syntax
:FUNCtion:OPERation <operation>
<operation> ::= {ADD | SUBTract | MULTiply | INTegrate | DIFF | FFT
| SQRT | MAGNify | ABSolute | SQUare | LN | LOG | EXP | TEN
| LOWPass | HIGHpass | DIVide | LINear | TRENd | BTIMing | BSTate}
The :FUNCtion:OPERation command sets the desired waveform math
operation:
• ADD — S source2.
• SUBTract — Source1 - source2.
• MULTiply — Source1 * source2.
• INTegrate — Integrate the selected waveform source.
• DIFF — Differentiate the selected waveform source.
• FFT — Fast Fourier Transform on the selected waveform source.
• SQRT — Square root on the selected waveform source.
With the DSOX3ADVMATH advanced math license, these additional
operations are available:
• MAGNify — Magnify of the selected waveform source.
• ABSolute — Absolute value of the selected waveform source.
• SQUare — Square of the selected waveform source.
• LN — Natural logarithm on the selected waveform source.
• LOG — Common logarithm on the selected waveform source.
• EXP — Exponential (e
x
) on the selected waveform source.
• TEN — Base 10 exponential (10
x
) on the selected waveform source.
• LOWPass — Low- pass filter on the selected waveform source.
• HIGHpass — High- pass filter on the selected waveform source.
• DIVide — Divide operation on the selected waveform source.
• LINear — Ax + B operation on the selected waveform source.
• TRENd — Measurement Trend. The math waveform shows measurement
values for each cycle of a selected waveform source.
• BTIMing — Chart Logic Bus Timing on the on the selected digital bus.
• BSTate — Chart Logic Bus State on the on the selected digital bus.
When the operation is ADD, SUBTract, MULTiply, or DIVide, the
:FUNCtion:SOURce1 and :FUNCtion:SOURce2 commands are used to select
source1 and source2. For all other operations, the :FUNCtion:SOURce1
command selects the waveform source.