25
Running a labeling protocol
G5581A Microplate Labeler Quick Guide
Running a labeling protocol
VWorks Administrator or Technician privileges are required to make any changes to the
protocol task settings.
Running the protocol
The following procedure provides a simple example of how to run a protocol. Your
steps may vary depending on your protocol.
To run the VWorks protocol:
1
Log in to VWorks and open the protocol.
2
Ensure that the labware to be labeled matches the labware specified in the
protocol and that the labware is placed in the location specified in the protocol, for
example, BenchCel stacker 1.
3
Ensure that the Control Toolbar displays
.
If
is displayed, click the button to turn off the simulation mode.
4
Ensure that all the devices in the protocol are initialized.
Figure
Example of a labeling protocol in the VWorks window
5
In the VWorks window, click
Start
on the Control Toolbar.
6
When the
Run Configuration Wizard
appears, follow the instructions in the wizard
and click
Next
or
Finish
, as applicable:
