Repairing the Sampler
4
1100 Series WS MWS Reference Manual
129
Interface Board
1
Switch off the sampler at the main power switch.
2
Disconnect all cables from the existing interface board. Then loosen the
interface board holding screws and slide the board out of its holding rails.
3
Identify the interface board slot cover. Loosen the two holding screws, and
remove the cover.
4
Carefully insert the new interface board into the holding rails, and push the
board into the slot. Make sure the board plugs into the socket correctly.
5
Reconnect all cables to the new interface board.
6
Switch on the sampler.
When required
For all repairs inside the sampler or for installation of the board.
Tools required
Flat-head screwdriver.
Parts required
Interface board, see
C A U T I O N
The interface board is sensitive to electrostatic discharge. Always use the ESD strap
when handling electronic boards.
Summary of Contents for G1367A
