Agilent Technologies FieldFox MW N9913A, Service Manual

Page: 121 / 156

N9927-90003 7-27
FieldFox Analyzer Repair and Replacement Procedures
Removing and Replacing the Measurement Group Assemblies
Removing and Replacing the Measurement Group Assemblies
Tools Required
• T-8 TORX driver (set to 6 in-lb)
• T-10 TORX driver (set to 9 in-lb)
• Small flat blade screwdriver
• 5/16-inch open-end torque wrench (set to 10 in-lb)
• 9/16-inch open-end torque wrench (set to 21 in-lb)
• Repair and Re-assembly Kit . Refer to “Miscellaneous Parts” on page 6-13 .
WARNING
Before beginning any repair, remove the battery and disconnect external power.
Removing All Measurement Group Assemblies as One Unit
1. Separate the front and rear cases. Refer to “Separating the Front and Rear Cases” on page 7-10 .
2. Refer to Figure 7-18 . Disconnect the A5 System board to A3 FPIB cable, W14, at the A3 FPIB
connector using the small flat blade screwdriver. If replacing this cable, disconnect both ends.
3. Lift the measurement group assemblies out of the front case and position them to the side of the front
case as shown.
4. Disconnect the A2 LCD to A5 System board cable, W11, at the A5 System board connector. It is
necessary to first remove the adhesive tape that is over the connector. To replace this cable, refer to
“Replacing the A2 LCD, the LCD Shield, and LCD Cables” on page 7-23 .
5. The measurement group assemblies are now completely separated from the analyzer.
6. To remove the I/O panel, refer to “Replacing the I/O Side Panel, Doors, and Gasket” on page 7-14 .