Agilent Technologies E4428C, User Manual, Page: 652 / 700

628 Chapter 17
W-CDMA Downlink Digital Modulation for Receiver Test
Configuring Rear Panel Output Signals
2. Press
More (1 of 5)
>
More (2 of 5)
>
DPCH data-clk(DRPS28)
.
Notice that in row two of the table editor under the column
Signal
, the text
SFN reset-signal(DRPS5)
changed to
DPCH data-clk(DRPS28)
. This corresponds to the
Event2
connector listed in the
Rear Panel ports
column. Figure 17-33 shows what the ESG
display looks like after the DPCH data-clock selection is made.
Figure 17-33 Output Trigger Signal Selection
To exit this display, press either
Mode Setup
to return to the first-level W-CDMA softkey menu or press
Return
until you come to the desired softkey menu/display.
Deselecting an Output Signal
This procedure builds upon the previous procedure Selecting an Output Signal .
1. Press
More (3 of 5)
>
More (4 of 5)
.
2. Highlight the
Event2
connector listing.
3. Press
NONE(DRPS0)
.
Notice that the output signal selection listed in the
Signal
column has changed to
None(RPSO)
and is
shown in Figure 17-34 . The none indicates that there is no signal output selected for the corresponding
connector.
DPCH data-clock
Selected
DPCH data-clk(DRPS28)
Softkey