Agilent Technologies E4428C, User Manual, Page: 444 / 700

420 Chapter 15
W-CDMA Digital Modulation for Component Test
W-CDMA Downlink Modulation
5. Highlight the
Timing Offset
value
0
for the new 3 DPCH carrier in row 2 and press,
Edit Item
>
3
>
Enter
. Refer to, “Multicarrier Setup Page 2” on page 421 .
6. Highlight the
Initial Phase
value
0
for the new 3 DPCH carrier in row 2 and press,
Edit Item
>
8
>
Enter
. Refer to, “Multicarrier Setup Page 2” on page 421 .
7. Highlight the
Pre-FIR Clipping |I+jQ|
value for the new 3 DPCH carrier in row 2 and press,
Edit Item
>
50
> %. Refer to, “Multicarrier Setup Page 2” on page 421 .
NOTE
The E4438C allows you to clip each individual channel by setting the I+jQ pre-FIR and
post-FIR clipping percentage in the table editor and clip the composite waveform by setting
the I+jQ percentage using the
Composite Waveform Clip
softkey.
Figure 15-4 Multicarrier Setup Page 1