Agilent Technologies E4428C, User Manual, Page: 392 / 700

368 Chapter 12
Multitone Waveform Generator
Applying Changes to an Active Multitone Signal
Applying Changes to an Active Multitone Signal
If the multitone generator is currently in use (
Multitone Off On
set to On) while changes are made in the
Multitone Setup
table editor, you must apply the changes before the updated waveform will be
generated.
From the
Multitone Setup
table editor, press the following key to apply the changes and generate a
multitone waveform based on the updated values:
Apply Multitone
Storing a Multitone Waveform
In this example, you learn how to store a multitone waveform. If you have not created a multitone
waveform, complete the steps in the previous section,
“Creating a Custom Multitone Waveform” on
page 366 .
1. Press
More (1 of 2)
>
Load/Store
>
Store To File
.
If there is already a file name from the
Catalog of MTONE Files
occupying the active entry
area, press the following keys:
Edit Keys
>
Clear Text
2. Enter a file name (for example,
5TONE
) using the alpha keys and the numeric keypad with a maximum
length of 23 characters.
3. Press
Enter
.
The multitone waveform is now stored in the
Catalog of MTONE Files
.
NOTE
The RF output amplitude, frequency, and operating state settings are not stored as part of a
multitone waveform file.