Agilent Technologies E364XA Series, User Manual

Page: 86 / 220

Chapter 4 Remote Interface Reference
Output Setting and Operation Commands
85
4
VOLTage:STEP { <numeric value> | DEFault}
Set the step size for voltage programming with the
VOLT UP
and
VOLT DOWN
commands. See the example below.
To set the step size to the minimum resolution, set the step size to ‘‘
DEFault
’’.
The minimum resolution of the step size is approximately 0.35 mV (E3646A),
1.14 mV (E3647A), 0.38 mV (E3648A), and 1.14 mV (E3649A), respectively.
The immediate voltage level increases or decreases by the value of the step
size. For example, the output voltage will increase or decrease 10 mV if the
step size is 0.01. At
*RST
, the step size is the value of the minimum resolution.
VOLTage:STEP? [DEFault]
Return the value of the step size currently specified. The returned parameter
is a numeric value. ‘‘
DEFault
’’ gives the minimum resolution step size in unit
of volts.
Example The following program segments show how to use the
VOLT UP
or
VOLT DOWN
command to increase or decrease the output voltage with the
VOLT:STEP
command.
‘‘
VOLT:STEP 0.01
’’ Set the step size to 0.01 V
‘‘
VOLT UP
’’ Increase the output voltage
‘‘
VOLT:STEP 0.02
’’ Set the step size to 0.02 V
‘‘
VOLT DOWN
’’ Decrease the output voltage
VOLTage:TRIGgered {
<voltage>
| MINimum | MAXimum}
Program the pending triggered voltage level. The pending triggered voltage
level is a stored value that is transferred to the output terminals when a trigger
occurs. A pending triggered level is not affected by subsequent
VOLTage
commands.
VOLTage:TRIGgered? [MINimum | MAXimum]
Query the triggered voltage level presently programmed. If no triggered level
is programmed, the
VOLT
level is returned.
* For E3646A/48A models **For E3647A/49A models