Agilent Technologies E2050, Installation And Configuration Manual, Page: 65 / 111

Chapter 4 65
Administration
Using the Telnet Utility
Using the Telnet Utility
This section explains how to access and exit the Telnet utility. It also
summarizes various Telnet commands you can use to administer the
E2050 LAN/GPIB Gateway. The section contents are:
n
Accessing the Telnet Utility
n
Exiting the Telnet Utility
n
Summary of Telnet Comands
Accessing the Telnet Utility
If you need to use Telnet commands, first use this procedure to access the
Telnet utility:
1 If you are on an HP-UX or Windows 2000/NT client computer
system,
login
. Also, if you are using a Windows 95/98/Me or a
Windows 2000/NT client computer system, do the following:
n
From the Windows 95/98/Me task bar at the bottom of the
screen, select
Start
|
Programs
|
MS-DOS Prompt
. The
MS-DOS window opens.
n
From the Windows 2000/NT Program Manager, select
Main
.
Then select
MS-DOS Prompt
. The MS-DOS window opens.
2 If you know the IP address and hostname of the Gateway, do the
following, where
IP_address is the IP address of the E2050
LAN/GPIB Gateway. hostname is the hostname (Internet domain
name) of the E2050 LAN/GPIB Gateway.
n
If you are using an HP-UX client system, at the HP-UX system
prompt, type:
telnet
IP_address (or) hostname
Return.
n
If you are using aWindows 95/98/Me/2000/NT client system, at
the
>
prompt in the MS-DOS window, type:
telnet
IP_address
(or) hostname
Enter