Agilent Technologies DSO9024H, User Manual, Page: 46 / 102

Using the Oscilloscope
46
To set the oscilloscope to trigger on an edge
1 Press and release the
[Source]
key until the desired source LED is
illuminated.
You can choose any of the channels, the Aux, or Line as the source for an edge
trigger.
2 Press the
[Slope]
key until the desired slope LED is illuminated.
You can have an edge trigger on a rising or falling edge.
3 Press the [Sweep] key until the Trig’d LED is illuminated.
The oscilloscope will wait for the edge before initiating a sweep.
4 Turn the [Level] knob to adjust the voltage level at which the oscilloscope
will trigger.