61
3 Installing BenchCel Microplate Handler
Installing the shield
BenchCel Microplate Handler User Guide
Installing the shield
About this topic
This topic explains how to install the safety shield on the front of the BenchCel
Microplate Handler. Additional shields may be required depending on the workstation
configuration. Typically, the BenchCel Microplate Handler and workstation safety
equipment will be installed for you.
WARNING
Changing the configuration or components of the installed workstation might
invalidate the safety compliance and lead to personal injury or equipment damage.
Before you start
Make sure you have the following:
•
3-mm hex wrench
•
Low-head M5 screws (supplied)
•
1 shield for each pair of stackers
For example, a BenchCel Microplate Handler with six stackers requires three
shields, as the following figure shows.
