Agilent Technologies AuroraPresto, User Manual

Page: 61 / 266

Setting up
Aurora Presto
Issue 7 - 05/02 3-13
Upstream
and
Downstream
Parameters
(ATU-C
only)
The following options are only available if an ATU-C
interface is fitted to your
Aurora Presto
and you have
selected ATU-C mode.
•
Max Add NM dB
—Enter the Maximum Noise
Margin above the Target Noise Margin for the
modem to stay in steady state.
•
Min NM dB
—Enter the Minimum Noise Margin
below the Target Noise Margin for the modem to
stay in steady state.
•
Target NM dB
—Enter the Noise Margin that you
want the modem to achieve to activate successfully.
Enter a value between 0 and 9000 kbps, in 32 kbps
increments, for the following options:
•
Min FBR kbps
—Minimum Fast Bit Rate.
•
Max FBR kbps
—Maximum Fast Bit Rate.
•
Min IBR kbps
—Minimum Interleaved Bit Rate.
•
Max IBR kbps
—Maximum Interleaved Bit Rate.
Downstream only
•
Max PSD
—Maximum Power Spectral Density. The
maximum ATU-C downstream power.
Tracer
Enables you to choose to display or not to display ADSL,
PPP and G.SHDSL messages.
Choose
Tracer None
to disable ALL the Tracer options.
Choose
Tracer ALL
to enable ALL the Tracer options.
The default is
Off
.
Choose
Trace DSL
to trace DSL events.
Choose
Trace DSL Alms
to trace DSL Alarms
(G.SHDSL only).
Choose
Trace EOC
to trace EOC events (G.SHDSL
only).
Choose
Trace PPP
to trace PPP events.
Parameters
(G.SHDSL
only)
This option is only available if you have a G.SHDSL
interface card fitted and you have selected
GL STU R
or
G STU C
in the
Type
option. See G.SHDSL Tests on
page 4-42 for details on setting up G.SHDSL tests.
481801-7.book Page 13 Thursday, May 23, 2002 10:46 AM