Agilent Technologies 969-9462, User Manual

Page: 224 / 306

16
Instructions for Use
General Information
General Information
This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not be
held responsible for any events occurring due to non-compliance, even
partial, with these instructions, improper use by untrained people, non-
authorized interference with the equipment or any action contrary to
that provided for by specific national standards. The Turbo-V 2000HT
series controllers are microprocessor-controlled, solid-state, frequency
converters with self-diagnostic and self-protection features.
The controllers drive (within ten steps) the Turbo-V 2000HT pump
during the starting phase by controlling the voltage and current respect
to the speed reached by the pump. They incorporate all the facilities
required for the automatic operation of the Turbo-V 2000HT pump
series.
Remote start/stop, pump status signals, forepump start/stop, interlock
control (for pressure switch, water flow switch. etc.) capability, are
provided via auxiliary connectors. The following paragraphs contain all
the information necessary to guarantee the safety of the operator when
using the equipment. Detailed information is supplied in the appendix
"Technical Information".
224/306 Turbo-V 2000HT Controller User Manual / 87-900-913-01 (O )