706
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_ts_cpower.fm
Channel Power Measurement Troubleshooting
Channel Power Measurement Troubleshooting
Possible Setup Issues
IMPORTANT
If the Access Probe Power measurement is currently selected and the Trigger Arm setting is
Continuous, all other measurements are disabled. Use the
command to set the trigger arm state to single and retry this measurement.
During remote operation of this measurement, you should configure the Trigger Arm to Single. See
. If single triggering is used during manual operation, press the START
SINGLE key to trigger each measurement.
Digital average power measurement results are affected by the Amplitude Offset value. Use the
command to set offset values.
The test set receiver’s expected signal amplitude and channel number (or frequency) must be set up correctly
for accurate measurements. This is normally done automatically (see
) but can
also be done manually (see
“Receiver Control” on page 194
) .
See
“Triggering of Measurements” on page 218
for a description of each trigger setting.