233
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_sync_callstate.fm
Call Processing State Synchronization
Call Processing State Synchronization
Call Processing State Query
The CALL:STATUS:STATE query returns the current call processing state.
This is a list of all possible values for this test application.
• “IDLE”
Idle is returned when the test set is not on a call.
• “PAG”
Paging is returned when the test set is in the process of paging the MS.
• “CALL”
Call is returned when an alert message is sent to the MS during a call setup due to a page.
• “CONN”
Connected is returned when the test set and the MS are connected on a call.
• “APR”
Access probe is returned when the test set has received an access probe.
• “REL”
Releasing is returned when the test set is in the process of releasing the MS from a call using over the air
signalling as part of a MS or BS originated release procedure.
• “HAND”
Handoff is returned when the test set is in the process of handing off the MS.
• “REG”
Registering is returned when the test set is in the process of performing a registration with the MS.
The following command returns the current state of a call:
OUTPUT 714;”CALL:STATUS:STATE?”
“Instrument Status Area” on page 699
for call processing state information.